[parisc-linux] Booting 715/100
Tue, 24 Aug 1999 14:21:35 -0700
I finally managed to build a kernel from the 08/07/99 tar file.
Now I can't boot it!
I might need to update the source tree again but need
to figure out how CVS can operate through HP's firewall.
Here's the /etc/bootptab entry:
Where "/linux/linux-2.2.3" is the kernel source tree.
I also wasn't sure about the difference between
CONFIG_PA7100 and CONFIG_PA7300 in the .config file.
I thought the 715/100 is an older machine before 7300LC
was available and thus is PA7100. Is this right?
"lifls Image" returns
lifls: Can't list Image; not a LIF volume
Whereas "file Image" says:
Image: lif file
<sigh>...can anyone explain this?
Lastly, I've attached the console output.
System model number: HP 9000/715/100
Processor revision 2.4 100MHz
Instruction Cache Size: 131072
Data Cache Size: 131072
Memory Size: 64 MB
Built in floating point coprocessor
Board Serial Number 40SM891817
BootRom Version 1.6
auto boot on
auto search on
Primary boot path: scsi.6.0
Alternate boot path: lan.000000-000000.0.0
Console path: graphics_1.1
Keyboard path: ps2
LAN Station Addresses: 080009-7B9230
BOOT_ADMIN> sea lan
Searching for potential boot device.
This may take several minutes.
To discontinue, press ESCAPE.
Device Path Device Type
BOOT_ADMIN> bo lan.184.108.40.206.3.52
Attempting to boot.
Loading Initial Program Loader
ERROR: Cannot load IPL, error detected
Boot process failed. press <ESCAPE> to Continue.